Emerson UW Manuel Du Propriétaire

Lock

Washer

Hex Nut

Deck Plate

Metal

Mounting Plate

UW/UWL

Tank

3/4" Screws (2)

Snap-Connect

Fitting (3 pieces)

Plastic Mounting Gasket

Equipment You May Need:

For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing
or using this hot water faucet.

Make sure that all electrical wiring and connections conform to local codes.

A standard 120-volt grounded electrical outlet is required under the sink for the faucet’s electrical power.

The wall outlet powering the tank must have electrical power supplied to it continuously.

This outlet must be fused and should not be controlled by the same wall switch that operates a food
waste disposer, unless you have a SinkTop Switch

™

from InSinkErator

It is recommended that a dedicated control valve be installed on the cold water line supplying water
to this system.

If you suspect elevated levels of chlorine in your water, it is recommended to use our water
filtration system.

The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa).
If it does, this will prevent your unit from operating properly.

Moving parts inside the tank causing a rattling noise is normal.

WHAT YOU SHOULD KNOW BEFORE YOU BEGIN

Equipment Required:

Drill

T-fitting

Dedicated control valve

Adjustable wrench

Phillips and flat blade screwdrivers

Pencil

Tape measure

Level

Anchors for drywall

Hole saw

Basin wrench

Hole punch

If you intend to use the sprayer hole in your sink for your faucet, you may need a basin wrench and a
1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line.

See Step 1-B.

If you need to cut a mounting hole in your stainless steel sink, you may need a 1

⁄

" - 1

⁄

" hole saw made

for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other
than stainless steel.

WHAT YOU NEED TO GET STARTED

COMPONENTS IN THIS PACKAGE