Omega CNiS16 Manuel D’Utilisation
37
ENTER OUTPUT 1 MENU:
Press
a
1) Press
a, if necessary, until CNFG prompt appears.
Press
d
2) Display advances to
INPT Input Menu.
Press
a
3) Press
a, if necessary, until display advances to OUT1 Output
1 Menu.
Press
d
4) Display advances to
SELF Self Submenu.
SELF SUBMENU:
The Self Option allows the output of the instrument to be controlled manually
from the front panel.
from the front panel.
Press
d
5) Display flashes the current setting of Self,
ENBL Enabled or
DSBL Disabled.
Press
b
6) Press the
b button to select between Enable and Disable.
Press
d
7) If Self
ENBL Enabled was selected, display shows STRD
stored message momentarily and then advances to the next
menu (Output 1 setting is completed).
menu (Output 1 setting is completed).
On the Run Mode display shows MXX.X The output is now
under the direct control of the operator and can be adjusted in
the Run Mode (M00.0 to M99.9), by pressing the
under the direct control of the operator and can be adjusted in
the Run Mode (M00.0 to M99.9), by pressing the
b and c
buttons, where M calls for manual (Self) control. For example,
setting of M50.0 of an analog output of 0 to 10 Vdc would
produce roughly 5 Vdc at the output.
setting of M50.0 of an analog output of 0 to 10 Vdc would
produce roughly 5 Vdc at the output.
8) If Self
DSBL Disabled was selected, display shows STRD
stored message momentarily and then advances to
ooLO
Minimum/Percent Low Submenu of Output 1 Menu.
There is a shorter way to Enable or Disable SELF Mode. From
a Run Mode press
a Run Mode press
d and then press a. SELF Mode is Enabled
now. Press
b or c to display MXX.X To Disable SELF press d
and then press
a. Display goes to the Run Mode. SELF Mode
is Disabled now.
MINIMUM/PERCENT LOW SUBMENU:
Specify in percent, the minimum value (0000) for control output. If the output is
analog proportional (Current or Voltage), then the minimum voltage or current, in
percent, is specified. If the output is time proportional (Relay, SSR or Pulse),
then the minimum duty-cycle, in percent, is specified.
Press
d
9) Display flashes 1st digit of previous “Percent Low” setting.
Press
b & c 10) Use b and c buttons to enter a new value for “Percent Low”.
Press
d
11) Display shows
STRD stored message momentarily and then
advances to
ooHI
Maximum/Percent High Submenu.