Grizzly G1010 Manuel D’Utilisation
G1010 4" x 6" Metal-Cutting Bandsaw
-19-
Components and Hardware Needed:
Qty
V-Belt ..................................................................1
To install the V-belt:
1. UNPLUG THE BANDSAW!
2. Lift the motor and slip the V-belt over both
pulleys as shown in
Figure 14. Make sure
the belt is on parallel sheaves.
V-Belt
Figure 16. V-belt in place and tensioned.
3. Lower the motor, apply downward pres-
sure on the motor base and adjust the V-
belt tension knob to tension the belt (see
Figure 15). Apply enough tension so the belt
deflects about
belt tension knob to tension the belt (see
Figure 15). Apply enough tension so the belt
deflects about
1
⁄
2
" with moderate pressure
when pinched together at the points shown
in
in
Figure 16.
4. Close the pulley cover.
Figure 15. V-belt tension knob.
V-Belt Tension Knob
Figure 14. Installing V-belt.