Graco Inc. TI14428A Manuel D’Utilisation
Installation
12
313869B
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod
[0.75 in. (19 mm) diameter maximum], insert
the bar (A) through the hole in the manifold as
shown in F
[0.75 in. (19 mm) diameter maximum], insert
the bar (A) through the hole in the manifold as
shown in F
IG
. 3.
NOTE: Use the 1/8 in. alignment slot (P) to
assist in orienting the gun.
assist in orienting the gun.
Secure the gun to the bar by tightening the
mounting screw (B).
mounting screw (B).
Stationary Support
To mount the gun on a stationary support, refer
to F
to F
IG
. 4 and to the correct mounting hole lay-
out for your gun, page 30 - 31.
1. Align the gun or manifold with the align-
ment pins. Locate alignment slot and holes
per the mounting hole layout.
per the mounting hole layout.
2. Secure the gun to the support with two M8
x 1.25 capscrews (C). The screws must be
long enough to engage the threaded holes
to a depth of 1/4 in. (6 mm).
long enough to engage the threaded holes
to a depth of 1/4 in. (6 mm).
F
IG
. 3: Reciprocating Arm Mount
B
P
A
TI14433A
F
IG
. 4: Stationary Support Mount
C
TI14434A
TI14435A
Guns without manifold
Guns with manifold
C