Wagner SprayTech Finish 250 Manuel D’Utilisation

10

1.  Unscrew the dust protective cap (Item 1).
2.  Ensure that the sealing surfaces of the connections are 

clean.

 

Ensure that the red inlet (2) is inserted in the coating ma-
terial inlet (5).

3.  Use the enclosed 41 mm wrench to screw the union nut 

(3) at the suction hose (4) onto the coating material inlet 
(5) and tighten it.

4.  Screw the union nut (6) at the return hose (7) to the con-

nection (8) (22mm).

1.  Screw the high pressure hose (10) onto the hose connec-

tion

2.  Screw the spray gun (11) onto the high pressure hose
3.  Tighten all union nuts on high pressure hose so that no 

coating material can escape.

4.  Screw the tip holder with the selected tip onto the spray 

gun, align tip and tighten union nut.

When unscrewing the high pressure hose, 
hold fi rmly on the hose connection with a 
22mm wrench.

STARTUP

Connection must always be carried out via 
an appropriately grounded safety outlet with 
residual-current-operated circuit-breaker.

Before connecting the unit to the mains supply, ensure that 
the line voltage matches that specifi ed on the unit’s rating 
plate.

1.  Unscrew the dust protective cap (Item 1).
2.  Ensure that the sealing surfaces of the connections are 

clean.

    Ensure that the red inlet (2) is inserted in the coating ma-

terial inlet (5).

3.  Screw the union nut (6) on the return pipe (7) onto the 

connection (8).

3.  Hang the return pipe (7) into the hopper and screw the 

upper hopper (9) onto the coating material inlet (5).

if using hopper with cleaning ring (TopClean) step 5 and 6
5.  Fix TopClean on hopper upside
6.  Plug in return pipe into TopClean and screw on union nut

2
5

6

1

4

3

9

8

7

7

8

11
10