Multiquip 8FP Series Manuel D’Utilisation

 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
FIGURE 38. 
11) If the Floor Planer is powered by an engine, 
reconnect the engine spark plug wire. If powered by 
an electric motor and the machine is to be used 
immediately, reconnect the extension cord or Floor 
Planer to the power source.  Determine that the 
ON/OFF switch located on the operator handle is in 
the OFF position. 
 

 

 
UNEXPECTED MACHINE START UP CAN RESULT 
IN PROPERTY DAMAGE AND/OR PERSONAL 
INJURY. 
INSTALLING A REPLACEMENT BEARING ON THE 
V-BELT SIDE. 
 
Application: All Models. 
Tools Required: 
1 each, 9/16 inch wrench. 
1 each, 7/16 inch wrench. 
1 each, torque wrench, 35 ft lbs (47 Nm.) capacity with 
9/16 inch socket. 
1 each, 5/16 inch Allen  wrench. 
1 each,  pliers for large, external type snap rings. 
1 each, shop press. 
 
Parts Required: 
1 each, PN 29020-016 sealed ball bearing. 
1 each, container of bearing  and shaft locking grade, 
anaerobic adhesive/sealant. 
1 each, PN 290020-011 snap ring (if required). 
1 each, PN 29020-015 driveshaft (if required) 
 
1) If the Floor Planer is powered by an engine, 
disconnect the spark plug wire. If powered by an 
electric motor, disconnect the extension cord or Floor 
Planer from the power source. 
 
2) Position the Floor Planer on a suitable work surface 
with the V-belt approximately at waist level. 
3) Using the 9/16 inch wrench, remove the belt guard 

from the main frame. Clean the inside of the belt guard 
with  an  appropriate solvent. Check for signs of wear 
and damage. 
 

 

 
Observe all applicable safety precautions for the 
solvent. 
 
4) Remove the V-belt and driveshaft pulley. Refer to 
INSTALLING A REPLACEMENT V-BELT OR PULLEY 
for specific information. 
 
5) Using the 5/16 inch Allen wrench and 9/16 inch 
wrench, remove the bearing block/driveshaft assembly 
from the main frame. For accuracy  and  alignment 
purposes, the main frame incorporates tapped holes to 
properly position the capscrews. 
 
6) Position the driveshaft assembly on a suitable work 
surface. Use the snap ring pliers to remove the snap 
ring. FIGURE 39. Remove the spacer. 
 

 

 
Wear safety glasses and other appropriate safety 
apparel when removing the snap ring or 
performing any work with an arbor press. Caution 
all onlookers about the possibility of flying debris 
and personal injury. 
 
7) Position the driveshaft assembly in a suitable arbor 
press.  Determine that the outer race of the bearing is 
properly supported. Press the bearing/driveshaft 
assembly from the bearing block.  FIGURE 40. 
Reposition the assembly  and press the bearing from 
the bearing block. FIGURE 41. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
FIGURE 39