Grizzly G0453 Manuel D’Utilisation
-36-
g0453/g0454 (Mfg. since 3/08)
Setting/Replacing
Knives
Planer knives are extremely sharp and can
quickly cause a serious injury to your hands
or fingers. Always wear heavy leather gloves
when handling these knives to reduce the
risk of cutting injuries.
setting the height of the knives correctly is cru-
cial to the proper operation of your planer and
is very important in keeping the knives sharp. if
one knife protrudes higher than the others, it will
do the majority of the work, dull much faster, and
produce poor cutting results.
cial to the proper operation of your planer and
is very important in keeping the knives sharp. if
one knife protrudes higher than the others, it will
do the majority of the work, dull much faster, and
produce poor cutting results.
the knife gauge that is included with the Model
g0453/g0454 is designed to set the knives
0.059" higher than the cutterhead surface.
g0453/g0454 is designed to set the knives
0.059" higher than the cutterhead surface.
Note: If you need to replace or sharpen a knife,
you can remove the knife from the cutterhead dur-
ing
you can remove the knife from the cutterhead dur-
ing
Step 4 of the following procedure. Thoroughly
clean out any debris from the knife slots before
replacing the knives.
replacing the knives.
Replacement knives are available through Grizzly
(refer to
(refer to
Page 28 for options).
tools Needed
Qty
hex Wrench 2.5mm (g0453)............................. 1
Wrench 10mm (g0453) ..................................... 1
hex Wrench 3mm (g0454)................................ 1
Wrench 12mm (g0454) ..................................... 1
Knife gauge ...................................................... 1
Wrench 10mm (g0453) ..................................... 1
hex Wrench 3mm (g0454)................................ 1
Wrench 12mm (g0454) ..................................... 1
Knife gauge ...................................................... 1
to adjust the height of the knives:
1. disConnECt plAnEr FroM poWEr!
2. remove the dust hood and the top cover to
expose the cutterhead.
3. remove the belt cover, then rotate the
cutterhead pulley to give you good access to
one of the knives.
one of the knives.
Note for G0454 Only: The cutterhead for
the Model G0454 ships with both springs and
jack screws to adjust the knife height (see
the Model G0454 ships with both springs and
jack screws to adjust the knife height (see
Figure 34)—which one you use is up to your
personal preference. However, you should
remove the components that you will not use
from the cutterhead before proceeding.
personal preference. However, you should
remove the components that you will not use
from the cutterhead before proceeding.
Jack Screw
(G0454 Only)
(G0454 Only)
Gib
Gib Bolt
Spring
Knife
Loosen
Tighten
Tighten
figure 34. Cutterhead components (g0454
cutterhead shown).
4. if you have not already done so, loosen
the cutterhead gib bolts until the knife is
completely loose, then position the knife
gauge over the knife so that the knife edge
is directly under the center pad, as shown in
completely loose, then position the knife
gauge over the knife so that the knife edge
is directly under the center pad, as shown in
figure 35.
figure 35. Knife gauge correctly positioned over
the knife (g0453 cutterhead shown).
Center
pad
Knife
gauge