Ryobi AG451 Manuel D’Utilisation

Page 12

See Figure 9.

After extended use, the guard may become worn and need
adjustments or replacing. If you drop your grinder and
damage the guard it may also be necessary for you to
replace it.

PROCEED AS FOLLOWS WHEN REPLACEMENT IS
REQUIRED:
■ Unplug your grinder.

Failure to unplug your grinder could result in accidental
starting causing serious injury.

■ Remove and reassemble parts as shown in figure 9.
■ Depress spindle lock button and rotate clamp nut until

spindle locks.

■ Using the wrench provided, loosen and remove clamp

nut from spindle.

■ Remove accessory wheel and disc flange.
■ Using a screwdriver, loosen the clamp screw until the

guard can be adjusted or removed.

■ If you are making adjustments, rotate the guard to its

correct position as shown in figures 4, 5, and 9, then
retighten clamp screw securely

. Never use your grinder

without the guard in place and properly adjusted.
See Figures 4 and 5.

Note: Be sure the tabs on the guard are seated in the
groove in the bearing cap.

■ If you are replacing the guard, loosen the clamp screw

until the guard can be removed from the bearing cap.

■ Place the new guard on the shoulder of the bearing cap.

See Figure 9.

Note:  If the new guard will not fit, loosen the clamp
screw until they slide over the bearing cap.

■ Rotate guard to the correct position as shown in figure 9.
■ Tighten clamp screw securely.

Note: Be sure the tabs on the guard are seated in the
groove in the bearing cap.

Fig. 9

When servicing use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.

■ Reassemble disc flange, grinding wheel, and clamp nut.

Refer to "INSTALLING THE ACCESSORY WHEELS"
instructions on page 9.

■ Securely tighten the clamp nut with the wrench pro-

vided.

In normal wire brushing operations, the material being removed and brush bristles will fly off (up to 50 or more feet) with
considerable force. The potential for serious injury exists. To protect against this hazard, operators and others in the work
area must wear protective clothing and safety goggles, or full face shields worn over safety glasses with side shields.