Echo X767000193 Manuel D’Utilisation

The Barrier Bar is required when using grass or weed blades.  Units 

equipped with U-Handles do not require installation of the Barrier 

Bar.

1.  Position front handle on shaft and install Barrier Bar using four (4) 

5x35 mm screws and (4) new nuts included with kit.  Handle must 

be at least 10 inches (250 mm) from center of rear handle grip.

2.  Adjust handle position for comfortable operation, and tighten 

screws securely. 

1.  Position front handle on shaft and install Barrier Bar using two 

(2) 5x35 mm screws provided in kit.  Handle must be at least 10 

inches (250 mm) from center of rear handle grip.

2.  Adjust handle position for comfortable operation, and tighten 

screws securely.

The Barrier Bar is not a handle.

Flat edge of washers (O) must be against drive shaft.

 

 

 

 

 

1.  Install gearbox assembly on end of drive shaft taking care to 

engage the drive cable with the gear housing.

2.  Align the gear housing on the drive shaft and install the locating 

screw (N).

3.  Tighten the two (2) side clamping screws (M).