Echo PAS-265 Manuel D’Utilisation

The attachment will operate immediately when the engine starts 

and could result in loss of control and possible serious injury. Keep 

movable parts of the attachment off the ground and away from 

objects that could become entangled or thrown.

1.  Stop Switch

  Move stop switch button (A) forward, away from the STOP posi-

tion.

2.  Choke Lever
  Move choke lever (B) to Cold Start (

) Position.

3.  Purge Bulb

  Pump purge bulb (C) until fuel is visible and flows freely in the 

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4.  Recoil Starter

  Lay the unit on a flat area and keep movable attachment parts clear 

of all obstacles. Firmly grasp right hand grip and throttle trigger 

lockout with left hand and fully depress throttle trigger to wide open 

position. Rapidly pull recoil starter handle/rope (D) until engine 

fires (or maximum five [5] pulls).

5.  Choke

  After engine fires (or 5 pulls), move choke lever back to Run 
  (

) position.  Hold throttle trigger and throttle trigger lockout 

fully depressed, and pull recoil starter starter handle/rope until en-

gine starts and runs. Release throttle trigger, and allow unit to warm 

up at idle for several minutes.

If engine does not start with choke in “Run” position after 5 pulls, 

repeat instructions 2 - 5.

6.  Throttle Trigger

  After engine warm-up, gradually depress throttle trigger to increase 

engine RPM to operating speed.