Echo PAS-265 Manuel D’Utilisation

Level 1.

Tools required:    5 mm Hex Wrench, Clean Rag

Parts Required:   POWER BLENDX

 8 oz. (P/N 91014) or Lithium    

 

 

 

Base Grease.

The drive shaft must  be lubricated with high temperature auto-

motive grease every 25 hours of operation, otherwise drive shaft 

assembly overheating and failure can result.

1.  Loosen clamping knob (A).
2.  Pull locator pin (B) and rotate 1/4 turn counter clockwise to lockout 

position.

3.  Remove attachment.
4.  Remove coupler (E) from upper drive shaft assembly by loosening 

clamping screw (C) and removing set screw (D).

5.  Remove upper flex cable (F), wipe clean, and apply a thin coating of  

1/2 oz. (15ml) of grease.

6.  Install cable. Make sure that the flex cable fully engages into the 

clutch square drive socket.  

7.  Slide coupler on upper drive shaft until fully seated, and align set 

screw hole in coupling with hole in upper drive shaft.

8.  Install and tighten set screw (D), and tighten clamping screw (C).