Tascam D00871320A Manuel D’Utilisation
62
TASCAM DP-01 Owner’s Manual
DP-01F
X App
endix
3 : DP-01FX Appendix
The DP-01FX differs from the DP-01 in a few important respects: it
provides balanced XLR connectors with switchable phantom power
for connecting condenser microphones, there is a built-in guitar/bass
tuner, it provides a multi-processor for the input signals, and noise
reduction, and it provides a reverb effect for the mixdown process.
provides balanced XLR connectors with switchable phantom power
for connecting condenser microphones, there is a built-in guitar/bass
tuner, it provides a multi-processor for the input signals, and noise
reduction, and it provides a reverb effect for the mixdown process.
Balanced XLR inputs
These XLR inputs
are wired with
are wired with
these pin assignments: 1=ground,
2=hot, 3=cold.
2=hot, 3=cold.
These inputs enable you to connect condenser microphones (the
same type as those used in professional recording studios).
same type as those used in professional recording studios).
The +48V phantom power supply allows you to power condenser micro
phones. Without such phantom power, many condenser microphones will
not work. Some, however, use internal batteries.
phones. Without such phantom power, many condenser microphones will
not work. Some, however, use internal batteries.
Never connect or
disconnect micro-
disconnect micro-
phones to or from the XLR connec-
tors with the phantom power turned
on.
tors with the phantom power turned
on.
Never turn the phantom power on
when unbalanced dynamic micro-
phones are plugged into the XLR
connectors.
when unbalanced dynamic micro-
phones are plugged into the XLR
connectors.
Consult any documentation that came with your microphones for full
details of power requirements, etc.
details of power requirements, etc.
Phantom power
The
PHANTOM
switch can be turned
ON
or
OFF
to supply +48V phantom
power to the XLR connectors. Phantom power is not supplied to the 1/4"
jacks.
jacks.
Input level controls
Use the input level controls the same way you would microphones that use
1/4" jacks.
1/4" jacks.
However, some microphones are more powerful than others, and you may
need to turn down the control to prevent overloading.
need to turn down the control to prevent overloading.
Tuning a guitar
The built-in tuner allows you to tune a guitar or bass connected to
input
input
A
only.
Press the
MULTI
key and the
REVERB
key together:
Play a single string. The DP-01FX makes its “best guess” at the note,
shows the value, and provides an indication of whether it’s sharp or
flat. This is a very flat F#:
shows the value, and provides an indication of whether it’s sharp or
flat. This is a very flat F#:
DP-01_OM_E.book 62 ページ ２００５年６月１３日 月曜日 午後７時１４分