Dakota Digital LAT-NR210 Fascicule

LAT-NR210 

LED Tail Lights for 1957 Chevy Car 

 

MAN#650185 

1.  Remove the three screws that secure the tail light lens and remove the lens. 
2.  Remove the light bulb 
3.  Push and twist to remove the plastic wire socket from the back side of the housing. 

   

 

4.  Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is 

recommended. 

5.  Remove the lock nut and flat plastic back plate from the back of the new LED assembly. 

 

   

 

 

 

6.  Make sure that one wire is still going through each hole in the 

aluminum spacer.  Insert the new LED assembly through the hole 
where the original bulb and connector were located.  Use caution 
when feeding the wires through to avoid damaging the wire 
insulation. 

 
7.  Guide the wires through the larger hole in the plastic back plate and slide 

the back plate onto the stud sticking out the back side of the housing. 
Ensure wires are not pinched to avoid shorting! 

8.  Secure the plastic back plate from the back side of the tail light housing 

with the supplied #6 lock nut. 

9.  Make sure the original lens gasket is in place and replace the tail light 

lens.  Tighten the screws down carefully. 

 
   

 

MAN#650185