Havis-Shields CD-PULS750 Manuel D’Utilisation

 

CD-PULSAR-INST-9-06 

 

- 3 - 

 

•  Protective glow ring (bezel) helps prevent lens breakage and provides an 

indication that the light is on if placed face down. 

•  Bulb mount design allows replacing bulb quickly without tools. 
•  Quartz halogen bulbs provide brilliant white light and last up to 100 hours. 

•  Standard 9 foot coil cord minimizes voltage drop for maximum power. 

 

 
Part Number  

 

Dash mounting clip for mounting the Pulsar & Genesis handheld  
light unit 

CD-RR-46 

 

Hypalon Rubber Ring For 6" reflector diameter 

Hypalon Rubber Ring For 7” reflector diameter 

CD-H1100W   

Replacement bulb for CD-PULS500 

CD-H2100W   

Spot replacement bulbs for CD-PULS750  

Flood replacement bulbs for CD-PULS750 

 
CD-PULS500 

1.    Remove the rear cap by twisting counter     
       clockwise. 
2.  Remove wire lead from bulb, removed 

spring clip and pull bulb out of reflector 

3.  Take new bulb out of box. Handle bulb only 

by rear terminal. DO NOT HANDLE 
GLASS PORTION OF BULB. 

4.  Insert new bulb through rear reflector mount 

so that bulb flange is seated flush against the 
back of the reflector housing. (Bulb will 
only fit flush one way). 

5.  Fasten bulb retainer spring clip in hole and 

notch. 

6.  Re-install wire lead onto back of bulb. 
7.  Replace rear cap by twisting clockwise. 

1.  Remove the rear cap by twisting counter  
     clockwise. 
2.  Grasp bulb mount assembly and withdraw  
     from head. Separate sections 
3.  Remove bulb to be replaced. Use cloth. Insert   
     new bulb and check for proper alignment. 
4.  Connect bulb mount sections and slide into  
     head.  Note alignment slots. 
5.  Check alignment in reflector. Two dowel pins  
     must protrude through reflector for proper   
     alignment. 
6.  Replace cap onto head, twist clockwise to  
      lock.