Harbor Freight Tools 67966 Manuel D’Utilisation

Page 2

SKU 9766-67

The planned mounting area must 

1. 

provide a flush fit to the bottom of the 

Lights (1).
Remove the lens from each Light and 

2. 

use the base of the Light as a template 

to mark mounting holes.
Ensure that the installation area has no 

3. 

hidden electrical or stereo lines before 

drilling.
Drill the holes, then secure each of 

4. 

the Lights with two Long Screws (2).  

Replace the lens.
See Wiring Diagram, page 4.

5. 

Connect the wire of each of the Lights 

6. 

to the Lead Wire (8) using a Wire 

Splice (4).  Insert the two wires into the 

holes of the Splice and use pliers (not 

included) to push down the metal tab.  

Close the cap to secure.  

7.  If the Lights are intended to be used 

along with the vehicle’s main lights, 

connect the lead wire to the headlight 

switch positive terminal.  

If the Lights are to work independently 

8. 

of the vehicle’s lights, mount the Switch 

at a convenient location with the two 

Short Screws (3).
Connect the Lead Wire to the middle 

9. 

terminal of the Switch (7).  
Connect the Fuse Holder (5) to the top 

10. 

terminal and connect to a 12V power 

supply.
Connect the Ground Wire (6) to the 

11. 

bottom terminal of the Switch and the 

other end to ground.  
This product is intended only to be 

12. 

mounted on the top of a vehicle’s cab.
Installation of these products must 

13. 

comply with DOT regulations and all 

applicable State and local laws.

THE MANUFACTURER AND/OR DISTRIBUTOR 

HAS PROVIDED THE PARTS LIST AND 

ASSEMBLy DIAGRAM IN THIS DOCUMENT AS 

A REFERENCE TOOL ONLy.  NEITHER THE 

MANUFACTURER OR DISTRIBUTOR MAKES 

ANy REPRESENTATION OR WARRANTy 

OF ANy KIND TO THE BUyER THAT HE OR 

SHE IS qUALIFIED TO MAKE ANy REPAIRS 

TO THE PRODUCT, OR THAT HE OR SHE IS 

qUALIFIED TO REPLACE ANy PARTS OF THE 

PRODUCT.  IN FACT, THE MANUFACTURER 

AND/OR DISTRIBUTOR ExPRESSLy 

STATES THAT ALL REPAIRS AND PARTS 

REPLACEMENTS SHOULD BE UNDERTAKEN 

By CERTIFIED AND LICENSED TECHNICIANS, 

AND NOT By THE BUyER.  THE BUyER 

ASSUMES ALL RISK AND LIABILITy ARISING 

OUT OF HIS OR HER REPAIRS TO THE 

ORIGINAL PRODUCT OR REPLACEMENT 

PARTS THERETO, OR ARISING OUT OF HIS 

OR HER INSTALLATION OF REPLACEMENT 

PARTS THERETO.