Hobart LXeC ML-130191 LXeH Manuel D’Utilisation
– 4 –
Installation, Operation and Care of
LXe SERIES DISHWASHERS
SAVE THESE INSTRUCTIONS
GENERAL
The LXe Series dishwashers are fully automatic, front-loading dishwashing machines. The LXe series
machines are capable of doing 24 to 34 racks per hour, depending on model.
machines are capable of doing 24 to 34 racks per hour, depending on model.
All LXe Series dishwashers shut down automatically 4 hours after last use to conserve energy.
All LXeH and LXeR dishwashers include Sense-A-Temp™ to insure proper hot water temperature
during rinse.
during rinse.
Standard equipment includes two 20" x 20" racks, electronic controls, drain pump, rinse pump, chemical
pumps, fill hose, and drain hose.
pumps, fill hose, and drain hose.
MODEL
DESCRIPTION
LXeC, LXePR
Fresh water rinse; low-temperature, chemical-sanitizing models for use
with 6% sodium hypochlorite solution (bleach) as the sanitizing agent*.
Note: If 8.40% bleach is to be used, contact Hobart Service or your
chemical supplier to change the sanitizer pump settings. (Charges may
apply)
Note: If 8.40% bleach is to be used, contact Hobart Service or your
chemical supplier to change the sanitizer pump settings. (Charges may
apply)
LXeH
Fresh water rinse with a built-in 70°F rise booster heater. This allows an
incoming water temperature of 110°F.
incoming water temperature of 110°F.
LXeR
Fresh water rinse with an internal energy recovery unit and a built-in 70°F
rise booster heater. Recommended incoming water temperature 55°F to
80°F.
rise booster heater. Recommended incoming water temperature 55°F to
80°F.
* - Sanitizing agent must be used in accordance with the EPA-registered label use instructions.