Hobart FT1000 Manuel D’Utilisation

– 30 –

Machine 

Configuration

ASR

Prewash

Upper

Prewash/wash

Lower

Wash

Upper

Power

Rinse

Dual

Rinse

Standard w/ ASR

949942-1

949942-2

949942-3

949942-3 949942-3 949942-5

Standard w/o ASR

Shorty w/ ASR

949942-2

949942-4

Shorty w/o ASR

949942-3

Prior to installing the conveyor, loosen the two stop nuts located on both the front 

and rear take-up assemblies on the outside of the tracks located at the load end 

of the machine. Thread the adjusting bolts out as far as possible moving the front 

and rear conveyor guides towards the machine entrance (Fig. 31).

STOP NUTS

ADJUSTING BOLT

Remove the conveyor drive chain from the conveyor gear motor.

Each dishwasher is supplied with the correct amount of conveyor. The conveyor 

sections must be connected together.

•  All conveyor sections are numbered: ROLL 1, ROLL 2, ROLL 3, ROLL 4, etc.; 

install them in numerical sequence.

•  Raise the loading platform and place a piece of cardboard under, around and 

above the platform to protect it from being scratched during conveyor installation.

•  Remove the chain cover on the unload end and then remove the drive chain 

from the conveyor gear motor so that the conveyor sprockets are free to rotate.

•  Position the first section of conveyor in line with the machine at the load end.

The flight links must lean towards the load end of the machine (Fig. 32).