Hobart FT1000S-ER-BD Manuel D’Utilisation

– 41 –

This may cause the dish limit arm to trip and stop the conveyor movement. If the 

conveyor stops for any reason during the 20 minute calibration period, the procedure 

should be rerun from the beginning to ensure proper calibration. 

After 20 minutes, unblock the photo detector. When the final rinse output turns

off and the display shows “---“ for the final rinse temperature, stop the conveyor.

Power off the machine by pressing the POWER button on the keypad. This saves 

the calibration data and completes the automatic calibration.

The conveyor gear motor is shipped with oil at the proper level in the speed reducer.

Lubricants are available from your local Hobart Service Office.

Based on water hardness and final rinse water usage, the machine will calculate

and notify the operator when it is time to delime. Refer to FT1000 Operation manual 

(F-47504) or FT1000 Service Manual (F-45518) to program the ‘Delime-Water 

Hardness’ and ‘Delime Concentration’ settings based on customer’s specific water

conditions and delime solution being used.

If service is needed on this machine, contact your local Hobart Service Office.