Beko D 5001 EM Manuel D'Instructions

4 GB

Permitted water pressure: 0,3 –10 

bar (= 3 – 100 N/cm² = 0,01-1,0Mpa)

Electrical connection: 220-240 Volts, 

10 Amps (see type plate)

Output: 1900-2200 W

Heat output: 1800 W

2006/95/EC: Low Voltage Directive

2004/108/EC: EMV Directive

DIN EN 50242: Electrical dishwasher 

for home use Testing procedures for 

practical service conditions

Because we continually strive to 

improve our products, we may change 

our specifications and designs without 

prior notice.

The necessary information for 

performance testing will be provided 

upon request. The request can be 

done by e-mail through:

Please do not forget to write the model 

code and stock code information of 

the appliance besides your contact 

information in the e-mail. The model 

code and stock code information can 

be found on the rating label, which is 

placed on the side of the door.

2

Check the appliance for transit 

damage. Never install or use damaged 

machines. If in doubt, contact your 

supplier.

•

See Notes for Installation on page 

6.

•

Have the grounding system 

installed by a qualified electrician. 

The manufacturer cannot be held 

liable for any damage caused by 

operating the appliance without 

proper grounding.

•

Before operating the system, 

please check that the information 

on the type plate corresponds to 

the information on your power 

supply.

•

The dishwasher must be 

disconnected from the mains 

during installation.

•

The appliance must not be 

connected to the mains using 

an extension cable. Extension 

cables do not provide the 

necessary safety (e.g. danger of 

overheating).

•

Always use the original plug 

delivered with the appliance.

•

The plug must be freely accessible 

after the appliance has been 

installed.

•

Do not allow children to play with 

the appliance.

•

Dishwasher detergents are caustic 

and may cause injury to the eyes, 

mouth and throat.  Please note the 

safety instructions provided by the