KitchenAid 9759405C Manuel D’Utilisation
9
INSTALLATION INSTRUCTIONS
Install Cooktop
Write down the model and serial numbers before installing the
cooktop. Both numbers are located on the left front underside of
the burner box.
cooktop. Both numbers are located on the left front underside of
the burner box.
Unpack the parts supplied with your cooktop. The parts shipped
with the cooktop depend on your model ordered. See “Tools and
Parts” section for a complete list parts supplied with your
cooktop.
with the cooktop depend on your model ordered. See “Tools and
Parts” section for a complete list parts supplied with your
cooktop.
Decide on final location for the cooktop.
The pressure regulator and flexible stainless steel gas supply line
connector can be assembled to the cooktop now or after the
cooktop is installed in the cutout. See “Make Gas Connection”
section.
connector can be assembled to the cooktop now or after the
cooktop is installed in the cutout. See “Make Gas Connection”
section.
To Install Backguard or Island Trim
Attach the backguard or island trim as required for your
installation. Attachment screws are in the literature package.
installation. Attachment screws are in the literature package.
Backguard
■
On 48" (121.9 cm) models with both grill and griddle, use
screws “A” and “B.”
screws “A” and “B.”
■
On 36" (91.4 cm) models with griddle only, use screws “A”
and “C.”
and “C.”
■
All other models use all 3 front screws.
■
On 48" (121.9 cm) models, 3 rear screws are required (not
shown).
shown).
■
On 36" (91.4 cm) models, 2 rear screws are required (not
shown).
shown).
Island Trim
■
On 48" (121.9 cm) models with both grill and griddle, use
screws “A” and “B.”
screws “A” and “B.”
■
On 36" (91.4 cm) models with griddle only, use screws “A”
and “C.”
and “C.”
Make Gas Connection
To Assemble Pressure Regulator:
1. Using 2 or more people, stand the cooktop on its side or
back.
2. Connect the flexible stainless steel connector to the pressure
regulator using a
¹⁄₂" male pipe thread adapter.
A combination of pipe fittings must be used to connect the
cooktop to the existing gas line. Shown following is a typical
connection. Your connection may be different, according to
the supply line type, size and location.
cooktop to the existing gas line. Shown following is a typical
connection. Your connection may be different, according to
the supply line type, size and location.
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
A
B
C
A. Gas pressure regulator
B. Regulator - Must be installed with arrow
B. Regulator - Must be installed with arrow
pointing up to cooktop bottom
C. Adapter - Must have
¹⁄₂
" male pipe thread
D. CSA approved flexible stainless steel gas
supply line
A
B
C
A
B
D
C