Crane Merchandising Systems 673 Manuel D’Utilisation
Basic Setup
HDC II Programming Guide
6730018
7
July, 2003
PROGRAMMING PROCEDURES
Basi c Setup
GAIN ACCESS TO THE SUPERVISOR MODE
1.
Press
. The display shows:
ENTER CODE. You must enter the four-
digit supervisor code within 6 seconds to gain access.
NOTE
A new machine has a factory-set supervisor code of 0000.
When you have entered the right code, you will hear two beeps and see
UNLOCKED in the display.
UNLOCKED in the display.
ENTER A NEW SUPERVISOR CODE
1.
Follow the steps in "Gain Access To The Supervisor Mode", PAGE 7.
2.
Press
. The display shows
SUPER XXXX. The X's represent the cur-
rent supervisor code. Use the number keys to enter a new code.
IMPORTANT
If you enter a new code, be sure to keep a written record of it.
There is no other way to access the SUPERVISOR mode.
3.
CONTINUE.
ENTER A FREEVEND CODE
1.
Follow the steps in "Gain Access To The Supervisor Mode", PAGE 7.
2.
Press
, then
until the display shows
FREE XXXX. The X's
represent the current freevend code. Use the number keys to enter a new
code. If the code is anything other than "
code. If the code is anything other than "
0000", it must be entered after the
key lock is turned in order to enable free vends.
3.
CONTINUE.