Sterling 100 Manuel D’Utilisation
Continuous Loss-in-Weight Blenders
Chapter 1: Safety
11
• Clean the blender and surrounding area DAILY, and inspect the machine for loose,
missing or broken parts.
• Shut off power to the blender when it is not in use. Turn the switch to the OFF
position, or unplug it from the power source.
Maintenance Responsibility
Proper maintenance is essential to safety. If you are a maintenance worker, you must make
safety a priority to effectively repair and maintain equipment.
safety a priority to effectively repair and maintain equipment.
Before removing, adjusting, or replacing parts on a machine, remember to turn off all electric
supplies and all accessory equipment at the machine, and disconnect and lockout electrical
power. Attach warning tags to the disconnect switch.
supplies and all accessory equipment at the machine, and disconnect and lockout electrical
power. Attach warning tags to the disconnect switch.
When you need to perform maintenance or repair work on a blender above floor level, use a
solid platform or a hydraulic elevator. If there is a permanently installed catwalk around your
blender, use it. The work platform should have secure footing and a place for tools and parts.
DO NOT climb on unit, machines, or work from ladders.
solid platform or a hydraulic elevator. If there is a permanently installed catwalk around your
blender, use it. The work platform should have secure footing and a place for tools and parts.
DO NOT climb on unit, machines, or work from ladders.
If you need to repair a large component, use appropriate handling equipment. Before you use
handling equipment (portable “A” frames, electric boom trucks, fork trucks, overhead cranes)
be sure the load does not exceed the capacity of the handling equipment or cause it to become
unstable.
handling equipment (portable “A” frames, electric boom trucks, fork trucks, overhead cranes)
be sure the load does not exceed the capacity of the handling equipment or cause it to become
unstable.
Carefully test the condition of lifting cables, chains, ropes, slings, and hooks before using
them to lift a load.
them to lift a load.
Be sure that all non-current carrying parts are correctly connected to earth ground with an
electrical conductor that complies with current codes. Install in accordance with national and
local codes.
electrical conductor that complies with current codes. Install in accordance with national and
local codes.
When you have completed the repair or maintenance procedure, check your work and remove
your tools, rigging, and handling equipment.
your tools, rigging, and handling equipment.
Do not restore power to the blender until all persons are clear of the area. DO NOT start and
run the unit until you are sure all parts are functioning correctly.
run the unit until you are sure all parts are functioning correctly.
BEFORE you turn the blender over to the operator for production, verify all enclosure
panels, guards and safety devices are in place and functioning properly.
panels, guards and safety devices are in place and functioning properly.
Reporting a Safety Defect
If you believe that your equipment has a defect that could cause injury, you should
immediately discontinue its use and inform the manufacturer.
immediately discontinue its use and inform the manufacturer.
The principle factors that can result in injury are failure to follow proper operating procedures
(i.e. lockout/tagout), or failure to maintain a clean and safe working environment.
(i.e. lockout/tagout), or failure to maintain a clean and safe working environment.