Smeg LS19-7 Manuel D’Utilisation

 

 

 

 

The dishwasher is equipped with a self-diagnostics system that is 
capable of detecting and signalling a number of possible faults. 
In the event of a fault or malfunction, before calling the After-sales 
service centre, we suggest that you first consult the troubleshooting 
guide below. 
If the problem persists even after implementing the recommended 
solutions, call the After-sales service centre after having carried out the 
following: 
•  making a note of the message displayed by the self-diagnostics 

system; 

• 

unplug the power cord  from the socket; 

• 

shut off the water supply tap. 

 
 
 
 
TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM 

 
 

The dishwasher’s AQUASTOP anti-flooding system has been 
activated (only for models equipped with the device). 
To disable the AQUASTOP: switch off the dishwasher and then 
switch it back on again. 
The triggering of the AQUASTOP device indicates the presence of a 
water leak; immediately after resetting the dishwasher it is therefore 
necessary to call the authorised After-sales service centre.

The system for limiting the water level in the dishwasher has 
been triggered. 
To reset the appliance, reprogram the wash by opening and closing 
the door and then pressing the START/PAUSE button (3) again. 
If the problem persists, call the authorised technical service centre. 

The dishwasher fails to heat the water. 
To reset the appliance, open and close the door. 
To determine the cause of this problem call the authorised technical 
service centre.