Tappan TDT4030W Manuel D’Utilisation

Dishwasher will not fill:

• Check water supply. Make sure that water supply is at "On" position instead of "Off" position.

• Check water pressure. Make sure the water pressure is at proper level. (Between 20 – 120 PSI)

Water found under the filter:

This is normal. After water is drained out, a small amount of water found under the filter area due to
different settings and shapes of food containers in the lower rack. The water will be drained out first in
next wash operation automatically.

INSTALLATION INSTRUCTIONS

Tools and Materials Required

You will need to have following tools to help you in the installation of your Washer:

. •

Scissors

• Phillips Screwdriver

• Standard Screwdriver

. •

Pliers

• Wrench

• Tape Measure

. •

Gloves

. •

Level

Note: Water Inlet hose, drain hose and quick connect adapter is preinstalled to the dishwasher from the

factory.

Unpacking Your Dishwasher

• Remove all packing materials including all adhesive tape holding the accessories inside and

outside.
.

• Inspect and remove any remains of packing, tape or printed materials before using the

dishwasher.

Steps for Installation

Please read installation instructions carefully and follow the steps below to hook up your dishwasher.

Installing Your Dishwasher:

Read install instructions carefully before installation.

Caution: If, after completing these steps, you are unsure that unit is properly installed, contact a

qualified installer. To ensure that your appliance is properly installed it is recommended
that it be installed by a certified installer.