VillaWare NDVLEM1000 Manuel D’Utilisation

villaware.com

ExTENSION CORD USE

A short power-supply cord is provided to reduce the risk resulting from becoming entangled

in or tripping over a longer cord. An extension cord may be used if care is exercised in its use.

If an extension cord is used, the electrical rating of the cord must be at least as great as the

electrical rating of the appliance. The extension cord should be arranged so that it will not

drape over the countertop or tabletop where it can be pulled on by children or tripped over

unintentionally.

SAVE ThESE INSTRUCTIONS

Features:

Removable Drip Tray & Grid

Water Reservoir

Lid

Brew Mode

Button

Warming

Zone

Froth Mode

Button

Frothing Tube

Filter holder

Single & Double Filters

Measuring Scoop/Tamper

with wrench for removing tip

Special Cautions:

Caution: StEaM PrESSurE

In order to avoid possible burns to body

parts and/or other injury from hot steam

and water or damages to the unit, never

remove the filter holder while your

VillaWare® espresso/cappuccino maker is

brewing coffee or frothing. The control

knob should be in the OFF position before

you can remove the filter holder to make

additional cups of coffee.

Caution

Please follow these important safety

instructions while using your unit:

Before removing any of the parts and

accessories as directed by this manual,

make sure the control knob on the front

of the unit is turned to the OFF position,

press the center of the control knob for

the OFF position and unplug the

appliance.

Do not remove the filter holder at any

time during the brewing process. Scalding

may result.

Use caution when removing the filter

holder. The metal parts may still be very

hot. Also, there may be hot water floating

on the top of the filter. hold it only by its

handle and dispose the brewed coffee

grounds by using the filter retention clip.

If coffee does not drip from filter holder,

it may be blocked. Turn off the appliance

and allow it to cool down. The blockage

may be caused by the coffee being too

finely ground or tamped too tightly. See

“TROUBLEShOOTING” on Page 11.

WhEN CLEANING ThE FROThING TUBE:

Place a frothing pitcher or large cup (with

at least 11-ounce capacity) half full of

water under the frothing tube cap. Make

sure the tip of the frothing tube is

submerged in liquid before turning the

control knob to the Froth position. Froth

the water for approximately 15 seconds,

then wipe clean the frothing tube and cap.

notE:

In order for your unit to work

properly time after time, clean the frothing

tip and tube after each use.

Center Power ON/OFF Button

with Light Ring to indicate

Power ON and Warming