Hobart ML-136126 Manuel D’Utilisation
– 3 –
INSTALLATION
UNPACKING
Remove the carton from around the machine. Remove the four bolts holding the machine to the skid.
Unpack the chopper cylinder assembly.
Unpack the chopper cylinder assembly.
Immediately after unpacking the chopper, check for possible shipping damage. If this machine is found to
be damaged after unpacking, save the packaging material and contact the carrier within 15 days of delivery.
be damaged after unpacking, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installation, test the electrical service to make sure that it agrees with the specifi cations on the
machine data plate.
machine data plate.
The four leg assemblies (Fig. 1) are removed and packed in a separate carton for shipment. Unpack and
assemble these legs by screwing them into the four tapped holes of the frame. The rubber feet on these
legs cushion the machine. Under normal operation, the machine need not be bolted down.
assemble these legs by screwing them into the four tapped holes of the frame. The rubber feet on these
legs cushion the machine. Under normal operation, the machine need not be bolted down.
ELECTRICAL CONNECTIONS
The electrical cord on this machine is equipped with a grounding- type plug which
must be connected to a properly grounded receptacle. If the receptacle is not the proper grounding
type, contact an electrician. Do not remove the grounding prong from the plug.
type, contact an electrician. Do not remove the grounding prong from the plug.
Choppers with three phase motors should be connected so that the hub drive runs counterclockwise
facing the cylinder assembly.
facing the cylinder assembly.
A check must be made to verify correct direction of rotation. Energize machine momentarily by turning
switch ON then OFF.
switch ON then OFF.
If rotation is incorrect, disconnect plug from electrical outlet, disassemble the plug and interchange any
two power leads (not the green ground lead). Then reassemble the plug and recheck.
two power leads (not the green ground lead). Then reassemble the plug and recheck.