Panasonic AW-PH405N Manuel D’Utilisation

6

M522 mm  ............................................................. 7

Camera cable  .................................................................... 1
Tally lamp  .......................................................................... 1
Tally mounting screws (M36 mm)  ................................ 2

M48 mm  ............................................................... 2

 Do not install the unit on any of its sides.

  Avoid using the unit in the kitchen and other locations with 

lots of steam and oily vapors.

  Mount the camera on the pan-tilt head only when you 

have finished installing it.

  The maximum weight which can be borne by this unit is 

.1 lbs (15 kg).

  Do not use a lens which will impair or upset the unit’s 

balance.  
Even if the weight by the unit is less than .1 lbs (15 kg), 
it cannot be used if the unit will be set off-balance by the 
lens mounted on it.

  Do not install the unit outdoors or in places where the 

temperature will be hotter than 11°F (45°C) or colder 
than °F (–5°C). 
Use the unit in places where the humidity is below 90%.

  Obtain separately the screws which will be used to install 

the unit since they are not provided with the unit.

  Do not hold or lift the unit by its rotating part. Doing so 

may cause malfunctioning.

  Do not connect a regular LAN line or telephone line to the 

CONTROL IN RP connector or COM connector on the 
unit. Doing so may cause malfunctioning.

  When performing work high off the floor or ground, make 

absolutely sure that the work is done by a qualified 
contractor.

  Do not turn the unit’s rotating part by hand. Doing so may 

cause malfunctioning.

  Dropping the unit or subjecting it to strong impact may 

give rise to malfunctioning.

  Leave a clearance of at least . ft (1 meter) from around 

the monitor when installing the unit.

  When mounting the camera on the unit, take sufficient 

steps to ensure that it will not become detached from the 
unit or fall onto the floor.

  A length of wire for preventing the camera from dropping 

is provided. Read the operating instructions first, and 
then be absolutely sure to attach the wire and take the 
necessary measures to prevent the camera from falling.

  Install the unit in such a way that the equipment mounted 

on it and its cables will not come into contact with anything 
when the pan-tilt head swivels, and set definite movement 
limits. 
( For details on the limiter settings, refer to the operating 

instructions of the controller.)

  When the unit is no longer going to be used, do not leave 

it in place, and be absolutely sure to remove it.