Epson II+ Manuel D’Utilisation

You can exit a submenu in one of the following ways:

l

To exit the submenu without making any changes, press   until the

cursor block returns to the main menu, or 

simply press ESC. This

cancels any changes you just made to the configuration.

l

To set your changes, press   to highlight 

** SAVE SETTINGS 

** and then

press 

When you exit Setup, the computer writes the changes to

CMOS RAM and reboots using the new settings.

When you finish using the Setup program, select the Exit option from

the main menu. The program displays a list of the current settings you just
made. Check the list before placing the settings in CMOS RAM. Below the
list you see this menu:

Exit without 

saving

** EXIT AND SAVE **

If any setting is incorrect, press 

The main menu appears again,

and you can correct the setting.

If you did not make any changes, or if you want to cancel the changes

you made, you can return to the OPERATION MENU or the MS-DOS
prompt without re-booting the computer. Press 1 to highlight the option

Exit without saving and press 

When the settings are correct, press   to highlight the option 

** EXIT

AND SAVE 

** and press 

The program writes the settings in CMOS

RAM, and then resets the computer using the new configuration.

If the computer displays a Setup error message during the power-on self

test, run Setup again and check all your settings.

Use the Memory option to change the amount of memory the system

recognizes after you install or remove an optional memory board. The maxi-

mum amount of memory MS-DOS uses is 640KB. Certain MS-DOS appli-

cations and other operating systems may require expansion memory You
can also use expansion memory to set up RAM disks for temporary storage,

using the VDISK.SYS driver. See your MS-DOS manual for information
regarding VDISK.SYS.