Kobe Range Hoods CH0030SQB Manuel D’Utilisation
9
2.
Align hood-mounting bracket to the two
screws on the wall and hook hood into
place. Tighten screws to secure hood to
the wall.
3.
For safety purposes, extra knockout
holes on the back of the hood are
provided. Knockout the holes. Remove
the baffle filters and attach screws to the
wall by accessing underneath the hood.
CAUTION: MAKE SURE HOOD IS
SUCURE BEFORE RELEASING
Wiring to Power Supply
SA FETY W A RN IN G
RISK OF ELECTRICAL SHOCK. THIS
RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE
BY
SPECIALIZED
ELECTRICIAN
IN
ACCORDANCE WITH ALL APPLICABLE
NATIONAL AND LOCAL ELECTRICAL
CODES. BEFORE CONNECTING WIRES,
SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
4.
Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with
wire connectors. Connect according
to color: black to black, white to white,
and green to green as shown on
Figure 12.
-
If necessary to hide the electrical wire
connections, push wires back into the
wiring box. Access the wire
connections underneath the hood.
Make sure wires do not slip between
motor or any moving parts to prevent
any damage.
Duct Cover Installation
5.
Use aluminum or steel pipe to connect
the plastic exhaust on the hood to the
ductwork above. Use duct tape to make
all joints secure and air tight as shown
on Figure 13.
6.
To convert ductwork to 7” round,
attached 7” round adapter (provided) to
the 6” round plastic exhaust..
7.
For 48” hood, prepare either separate
parallel connection or upside down Y-
Connection
for
proper
ductwork
installation. Refer to Figure 14.
Figure 12
Figure 13
Figure 14