Panasonic FV-08VSL2 Manuel D’Utilisation

MAINTENANCE    (REPLACEMENT OF LAMP ) CONTINUED 

1. Remove grille. (Squeeze mounting spring and pull 
    down) (Fig.22 of page 13)

2. Disconnect connector    or connector     from
    lighting unit. (Fig.26)

3. Replace the fluorescent lamp (Panasonic
    FHT32E35 32W) or the 4 W night lamp, 
    connect the connector     or connector     and 
    replace the grille. (Fig.27)

PRACTICAL GUIDE TO INSTALLATION

Fig. 26

Plug connector

Plug connector

Receptacle

Receptacle

Fluorescent lamp

4 W Night Lamp

14

4 inches or 6 inches roof jack, wall cap,
or soffit vent with backdraft damper

Mechanically connect duct to termination
and seal with mastic or approved foil
faced tape

2-3 ft straight run before elbow

In attic installation,
caulk box to drywall

Short piece of flexible duct helps
alignment and absorbs sound.
Clamps plus mastic or approved
foil faced tape at all flex joints

Foil tape tightly covers all metal
duct joints (glue PVC joints)

Insulation

Fig. 28

Properly insulate the area around the fan
to minimize building heat loss and gain.
(Fig.28)

Loose fill or batt insulation can be placed
directly over the fan housing in the attic.
Our fans and fan/light combination units 
do not create excessive heat that is a 
common problem with recessed light 
fixtures or some competitors  fan/light
combinations. Our efficient, cool-running
motors and our fluorescent lamp do not
create enough ambient heat to be subjected
to these limitations.

'

Fig. 27