Husqvarna 532 43 00-01 Manuel D’Utilisation

NOTE: You may now roll your tractor off the skid. Follow the

instructions below to remove the tractor from the skid.

WARNING: Before start ing, read, un der stand and fol low

all in struc tions in the Op er a tion section of this man u al. Be

sure tractor is in a well-ventilated area. Be sure the area in

front of tractor is clear of other peo ple and objects.

TO ROLL TRACTOR OFF SKID (See Op er a tion

section for location and function of con trols)

• Raise attachment lift lever to its highest po si tion.
•

Release parking brake by de press ing clutch/brake ped al.

• Place freewheel control in "trans mis sion dis en gaged"

position (See “TO TRANS PORT” in the Op er a tion

section of this manual).

• Roll tractor forward off skid.
Continue with the instructions that follow.

TO ADJUST SEAT (See Fig. 2):

• Grasp adjustment handle(A) and pull up, slide seat to

desired po si tion and release adjustment handle.

Fig. 2

ASSEMBLY

TRANSAXLE

02965

FRONT

BACK

ENGINE

Q. DEFLECTOR

SHIELD

Fig. 5

H. FRONT MOWER

BRACKET

W. FRONT GAUGE

WHEEL

X. SHOULDER

BOLT

Y. 1-1/4 O.D.

WASHER

Z. 3/8-16 LOCKNUT

Fig. 4

3. TURN STEERING WHEEL LEFT AND POSITION

MOWER (See Fig. 5)

• Turn steering wheel to the left as far as it will go and

position mower on right side of tractor with deflector

shield (Q) to the right.

2. ASSEMBLE FRONT GAUGE WHEEL (W) TO FRONT

OF MOWER (See Fig. 4)

CAUTION: Continuing to press the electric lift switch

after the mower deck has reached the minimum

or maximum position may result in damage to the

electric lift mechanism.The electric lift mechanism

is equipped with a thermal protection system. If the

system overheats or fails to operate, allow the sys-

tem to cool before attempting to operate again.

TO INSTALL MOWER AND DRIVE BELT

(See Figs. 3 - 15)

1. SET PARKING BRAKE LEVER AND LOWER AT-

TACHMENT LIFT (See Fig. 3)

• Depress clutch/brake pedal all the way down and hold.
• Pull parking brake lever up and hold, re lease pres sure

from clutch/brake pedal, then release parking brake

lever. Pedal should re main in brake position. Ensure

parking brake will hold tractor secure.

PARKING

BRAKE

LEVER

Fig. 3

• The attachment lift switch is used to raise and lower

the mower deck or other attachments mounted to your

tractor. Ignition must be on to operate this switch.

• Lower attachment lift to its lowest position.