JL Audio SB-N-PTHFNDR2/10W3v3/BK Manuel D’Utilisation
Continued on Next Page
SB-N-PTHFNDR2/10W3v3_INSTR_SKU#011234
SB-N-PTHFNDR2/10W3v3_INSTR_SKU#011234
S T E P 1 5
Place a supplied lock washer and flat washer onto each
hex bolt.
Place a supplied lock washer and flat washer onto each
hex bolt.
Place each bolt assembly through the holes on the extreme
ends of the flat bar.
ends of the flat bar.
Place a flat washer and nut onto the bolt that is exposed on
the backside of the metal, secure.
the backside of the metal, secure.
S T E P 1 4
The supplied flat bar needs to be mounted into the area that
is pictured. Follow STEPS 15 - 16.
The supplied flat bar needs to be mounted into the area that
is pictured. Follow STEPS 15 - 16.
There is a hole in the mounting bar that is off-set to one end
of the flat bar. The short side of the off-set is to be positioned
downward.
of the flat bar. The short side of the off-set is to be positioned
downward.
The top side of the mounting bar needs to be behind the
wiring harness, see picture.
wiring harness, see picture.
S T E P 1 3
Unplug the 12v socket and remove the side panel from the
vehicle.
Unplug the 12v socket and remove the side panel from the
vehicle.
This 12v plug will be covered by the Stealthbox®, once
installed. If this 12v socket is to be used after the installation
of the Stealthbox®, you will have to modify the wiring and
remount the socket else where.
installed. If this 12v socket is to be used after the installation
of the Stealthbox®, you will have to modify the wiring and
remount the socket else where.
S T E P 1 2
Remove the pocket from the side panel.
Remove the pocket from the side panel.
Page 3 • JL Audio, Inc 2007
S T E P 1 7
Place the side panel back into the vehicle that was removed
in STEP 13.
Place the side panel back into the vehicle that was removed
in STEP 13.
S T E P 1 9
Secure the bolt that was removed in STEP 10.
Secure the bolt that was removed in STEP 10.
Replace the cover that was removed in STEP 9.
S T E P 1 8
Mount the cargo net hook that was removed in STEP 11.
Mount the cargo net hook that was removed in STEP 11.
S T E P 1 6
Place a supplied lock washer and flat washer onto a hex bolt.
Place a supplied lock washer and flat washer onto a hex bolt.
Place this bolt assembly through the bottom end of the
mounting bar and through the hole in the metal.
mounting bar and through the hole in the metal.
Place a flat washer and nut onto the bolt that is exposed
behind the metal. Secure.
behind the metal. Secure.