Emerson I-0021 Manuel D’Utilisation

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98

NGA 2000

To activate a time controlled system calibration we have to set-up this in an own menu page.

For the 3 different SYSCAL-modes there is the possibility to

• 

enable/disable the activation

• 

determine start of time calculations (start time of current day)

• 

determine in which time intervals after start time the activation is done

Attention:
Other than in some AM-functionalities the interval time is to be input as interval hours. For
example, for a weekly calibration you have to calculate 24 h * 7 = 168 h.

The logic for the time calculations is as follows.

The basic is the respectively parameter „Start of interval time“ (SIV-time). By changing this
SIV-time or changing the „interval time“ (IV-time) the basic is new calculated as date of
current day and time of the SIV-Time (only entire hours possible). This basic stays valid (also
after a program reset!) until new values for SIV-time or IV-time are entered.

Basic-time = SIV-Time of current day

The next start of SYSCAL (ACT-time) happens at

ACT-time = Basic-time + n x IV-time 

(n = 0,1,2,3,...)

Is the basic time-time before present point of date/time then there are added further IV-times
until it is later.

System configuration and diagnostics...

↓

System Calibration...

↓

Times for interval operation...

↓