Emerson I-0021 Manuel D’Utilisation

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98

NGA 2000

If you press the 

88 

 -key or the 

→

→

 -key in the line "Analyzer and I/O-module expert

configuration..." of the "Main Menu", you will change to the following display:

From the menu "Expert Module Configuration" you can change to several submenus to
set up parameters for the measurement and calibration of your analyzer and analyzer
module. Besides you can set up the configuration for auxiliary modules. Which part of
these menus are important for you depends on the configuration of your NGA 2000
system.
In the following table you will find a short overview about the contents of the menus:

⇒ 

See "Analyzer module setup" and note below!

⇒ 

Configuration of the SIO and of the DIO's
installed in a platform or
in an MLT analyzer (auxiliary I/O's)

5.2
p. 83 - 98

⇒ 

Measurement set up and control

⇒ 

Calibration set up and control

⇒ 

Configuration of the SIO and of the DIO's
installed in the MLT analyzer module
(Local SIO/DIO)

⇒ 

Programmable logic control (PLC)

⇒ 

Programmable calculators

5.1
p. 3 - 82

⇒ 

Set up for micro processor controlled
auxiliary I/O modules

Note:

All submenus of "Analyzer module controls..." are the same like those of "Analyzer module
setup...", if you use an MLT analyzer or analyzer module (resp. TFID analyzer or analyzer
module)! If your analyzer is not such a type, the submenus of "Analyzer module
controls..." and "Analyzer module setup..." will look different, partially. Look at the
corresponding software manuals.

Measure

Channel

Back...

TAG

37.50 ppm

-- Expert Module Configuration --

Analyzer module controls...

Analyzer module setup...
I/O module setup...

I/O module controls...