Sun Microsystems 817-3630-11 Manuel D’Utilisation

Chapter 11

Using SunPCi III Software

131

▼

How to Configure Japanese Copy and Paste
Between Microsoft Windows and Solaris

To configure Japanese copy and paste functions, perform the following procedure.

1. Exit SunPCi III software.

2. Using the text editor of your choice, open the

$HOME/pc/SunPC.ini

file.

3. Add the following lines to the end of the file:

4. Save your changes and close the file.

The next time you start the SunPCi III 3.2.1 software, the Japanese copy and paste
functions should work.

Note –

Make sure that the

CodeSet

line specifies

eucJP

, as shown in Step 3. If you

try to substitute a different code or mistype the characters, Microsoft Windows
returns the following message:

Warning, bad clipboard translation

codeset specified in SunPC.ini file: codeset. Ignoring

. If you see

this message, click OK to continue. Microsoft Windows continues to work, but
Japanese copy and paste support is not enabled.

Printing From Microsoft Windows or
Linux Using Solaris Printers

This section explains how to configure your Microsoft Windows settings with
SunPCi III 3.2.1 software so that you can print using your Sun system’s network
printer.

When connecting a printer from your Sun system, do one of the following:

■

Connect the printer to the SunPCi III hardware to print from Microsoft Windows.

■

Connect the printer to the non-Sun hardware to print from Solaris.

There are hardware compatibility issues, particularly drivers, that might not work
properly if you try to print from Microsoft Windows when you are connected to the
non-SunPCi III Sun hardware.

[CopyAndPaste]

CodeSet=eucJP