Scag Power Equipment SWZ Manuel D’Utilisation
3
HYDRAULIC SAFETY
•
Keep body and hands away from pin holes or nozzles
that eject hydraulic fluid under high pressure. Use
that eject hydraulic fluid under high pressure. Use
paper or cardboard and not hands to search for leaks.
•
Hydraulic fluid escaping under high pressure may
have sufficient force to penetrate skin and cause
have sufficient force to penetrate skin and cause
seriousinjury. Ifforeignfluidisinjectedintotheskin,
it must be surgically removed within a few hours by a
doctor familiar with this form of injury or gangrene
may result.
•
Makesureallhydraulicfluidconnectionsaretightand
all hydraulic hoses and lines are in good condition
all hydraulic hoses and lines are in good condition
before starting the machine.
•
Hydraulic fluid is under high pressure. If you need
service on your hydraulic system, please see your
service on your hydraulic system, please see your
authorized Scag dealer.
INITIAL RUN-IN
First Day of Use or approximately 10 hours.
3
Checkforproperoperationofthesafetyinterlocks.
3
Check belts for proper tension at 2, 4 and 8
hours; adjust as needed.
3
Check speed control neutral adjustment. Adjust if
necessary, (see Adjustments, page 9) so that
enginewillnotstartunlessspeedcontrolleverisin
neutral and blade clutch is disengaged.
3
Check steering control neutral and adjust, if
needed, as indicated in the Adjustments Section.
3
Check tires for proper pressure (see Adjustments,
page 9).
3
Check for loose hardware. Tighten as needed.
3
Grease machine fittings:
•
2 caster wheel bearings
•
2 caster wheel pivots
•
2 or 3 spindles (bearings)
•
1 or 2 deck idler pivot arms
•
1 engine idler arm pivot
•
2 speed control shafts
•
2 neutral cam weldments
•
2 pivot weldments, pump control