Jenn-Air TC507 Manuel D’Utilisation

Installer: Leave Use and Care Guide with the homeowner.

Homeowner: Keep Use & Care Guide for future reference and for 
local electrical inspector’s use, if required.

■

Do not grasp console to move compactor.

■

Begin in the room where the compactor will be located.

1. Remove compactor from shipping carton. Remove all 

protective packaging materials such as tape and shipping 
pads. Use a mild solution of liquid household cleaner and 
warm water to remove waxy residue caused by protective 
shipping material. Dry thoroughly with a soft cloth. For more 
information, see the “Cleaning” section.

2. Check to be sure the power cord is attached to the cord clip 

on the rear of the compactor. 

3. Place the two corner posts from the carton on the floor near 

the compactor. Open the compactor drawer and remove any 
shipping materials or other items from the drawer. Do not 
remove the compactor bag. Grasp the handle and raise the 
front of drawer until it clears the drawer stops. Grasp sides of 
drawer and lift drawer out of compactor. Place the drawer on 
the two corner posts. 

4. Place the other two corner posts on the floor to the side of 

the compactor. Grasp the sides of the compactor cabinet and 
put compactor on its side on top of the corner posts. Remove 
the shipping base from the bottom of the compactor.