Samsung RSG307AABP Manuel D’Utilisation

Page de 64
06_
 
setting up
setting up your side-by-side refrigerator
GETTING READY TO INSTALL THE 
REFRIGERATOR
Congratulations on the purchase of your Samsung 
Side-By-Side Refrigerator. We hope you will enjoy the 
many state-of-the-art features and effi ciencies that this 
new appliance has to offer.
Selecting the best location for the refrigerator
•  Select a location with easy access to a water supply.
•  Select a location without direct exposure to sunlight.
•  Select a location with level (or nearly level) fl ooring.
•  Select a location with enough space for the 
refrigerator doors to open easily. See the diagram 
below.
•  Select a location that allows suffi cient space to the 
right,left, back, and top for air circulation. See the 
diagram below.
•  Select a location that allows you to move the 
refrigerator easily if it needs maintenance or service.
When moving your refrigerator
To prevent fl oor damage, be sure the front levelling 
legs are in the up position (above the fl oor). Refer to 
‘Levelling the refrigerator’ in this manual (page 8).
To protect the fi nish of your fl ooring while you are 
installing the refrigerator, place a large section of the 
cardboard carton under the refrigerator where you are 
working.
When installing, servicing or cleaning behind 
the refrigerator, be sure to pull the unit straight 
out and push back straight in after fi nishing.
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in 
place, you are ready to set up and enjoy the features 
and functions of the appliance. By completing the 
following steps, your Refrigerator should be fully 
operational. If not, fi rst check the power supply and 
electricity source or try the troubleshooting section at 
the back of this user’s guide. If you have any further 
questions, contact your Samsung Electronics service 
center.
1.  Place the Refrigerator in an appropriate location 
with reasonable clearance between the wall and 
the Refrigerator. Refer to installation instructions in 
this manual.
2.  Once the Refrigerator is plugged in, make sure the 
interior light comes on when you open the doors.
3.  Set the Temperature control to the coldest 
temperature and wait for an hour. The Freezer will 
get slightly chilled and the motor will run smoothly.
4.  After powering the Refrigerator, it will take a few 
hours to reach the appropriate temperature. You 
can store food and drinks in the Refrigerator after 
the temperature is suffi ciently cool.
2 ˝(50mm)
2 ˝(50mm)
46 ½˝ (1
181mm)
38 ⅜˝ (974mm)
40˝ (1016mm)
51 ½˝ (1308mm)
68˝ (1727mm)
at least ¼” (6mm)
at least ¼” (6mm)
at least ¼” (6mm)
at least ¼” (6mm)
Leg
Leg
Screw Driver
Screw Driver
CAUTION
DA68-02500A.indb   06
DA68-02500A.indb   06
2012.5.16   2:52:10 PM
2012.5.16   2:52:10 PM