Samsung RF266AB Manuel D’Utilisation

Setting Up

 

setting uP tHe ReFRigeRAtoR

Now that you have your new Refrigerator installed and in place, you are ready to set up and enjoy the features and 

functions of the appliance.

By completing the following steps, your Refrigerator should be fully operational. 

1.  Place the Refrigerator in an appropriate location 

with reasonable clearance between the wall and 

the Refrigerator. Refer to installation instructions in 

this manual.

2.  Once the Refrigerator is plugged in, make sure the 

interior light comes on when you open the doors.

3.  Set the Temperature control to the coldest 

temperature and wait for an hour. The Freezer will 

get slightly chilled and the motor will run smoothly.

4.  After powering the Refrigerator, it will take a few 

hours to reach the appropriate temperature. You 

can store food and drinks in the Refrigerator once 

the temperature is sufficiently cool.

01 
setting

 u

P

ReMoVing tHe ReFRigeRAtoR DooRs

If your entrance won’t allow the Refrigerator to pass easily 
through it, you can remove the doors.

Disassemble the Refrigerator doors

1.    With the door closed, remove the top table( 

 ) 

using a Philips screwdriver, and then disconnect the 
wires( 

 ). Remove hinge screws( 

 ) and ground 

screw( 

 )

2. Lift the door straight up to remove.

3.  With a Philips head screwdriver, remove the two 

screws(  

  ) attached to the lower left and right 

door hinges. 
With an Allen Wrench(3/16”), remove the two hex 
head bolts(  

 ) attached to the lower left and right 

door hinges. 
Remove the lower left and right door hinges(  

  ).

tools you will need

Philips screwdriver

Wrench

Allen wrench(3/16”)

Flat-blade screwdriver

Pliers

Check the accessory list below.

Water filter

(DA29-00003B)

Hex wrench

(DA80-00002C)

Compression 

fitting

(DA62-00305A)

Compression 

nut

(DA74-00070B)

Fastener

(DA60-00143B)

Washer

(DA80-00002C)