Samsung RF323TEDBWW Manuel D’Utilisation

 

setting up

1.  Remove 3 screws holding down the  TOP 

TABLE  ( 

1 ) and separate wires connected.

2.  Disconnect two connector ( 2 ) on the left side 

door. To remove the water coupler from the 
hinge, twist and pull it from the hinge. Remove 
the water line ( 

3 ) while pressing the marked 

part ( 

4 ) of the water line coupler. 

If a red clip is on the coupler, it must be 
removed before removing the tube.

3.  Pull and remove the hinge lever ( 5 ) . Remove 

the ground screw ( 

6 ) attached to the upper 

left door hinges with a philips screwdriver (+). 
Remove the upper left and right door hinges ( 

7 ).

4.  Lift the door straight up to remove.

5.  Remove the screw ( 8 ) attached to the 

lower left and right door hinges with a philips 
screwdriver (+). Remove the 2 hex head bolts 
( 

9 ) attached to the lower left and right door 

hinges with an allen wrench (3/16”). Remove 
the lower left and right door hinges ( 

10 ).

REATTACHING THE 
REFRIGERATOR DOORS

To reattach the fridge doors after you have moved
the fridge to its fi nal location, assemble the parts 
in reverse order.

1.  The Water Line must be fully inserted to the 

center of transparent coupler (Type A) or the 
Guide Lines (Type B) to prevent water leakage 
from the dispenser.

2.  Insert

 the clip in the install pack and check that it 

holds the line firmly.

DISASSEMBLE THE FLEX DOOR

1.   Take out the upper drawer by lifting it up.

2.  Remove the freeze room guard ( 1 ) by lifting 

the guard up.

CAUTION

2

3

4

Red Clip 

(1/4")

5

6

7

Allen wrench

10

8

9

1

1

Center of Transparent coupler

The Guide Lines

Dispenser

clip A (1/4”)  
(6.35 mm)

clip A (1/4”)  
(6.35 mm)

Type A

Type B

DA68-02603A-03.indb   8

13. 4. 25.   �� 2:12