Samsung RS20CR Manuel D’Utilisation

Check the dimensions of your entrance door.

Clean your refrigerator.

Wipe the inside and outside of your

refrigerator with a dry cloth.

Store food in the refrigerator.

Wait for at least two or three hours after

plugging your appliance in and before

storing food and other articles inside.

Check the dimensions of your entrance door to determine whether the refrigerator can pass through it.

Dimension of the Appliance

Allow sufficient space to install the

appliance on a flat surface.

If your appliance is not level, the

internal cooling system may not

work properly.

Width

Depth

Height

Dimension (mm)

855

756

1728

Remarks

With door

With hinge

INSTALLING REFRIGERATOR

Over 10cm

Remove all packing materials：

Remove the foam pad for the appliance before using it.

Allow a clearance of 10cm to the right, left and rear side when installing the appliance; as this will

help to reduce power consumption.

At level 2, 4, 6 and 8, LED marked with ( ) will fully light

up after blinking for 5 seconds .

( )

。

TEMPERATURE CONTROL

TEMPERATURE CONTROL （RS20NR**）

Cold

Normal

Colder

LED

CONDITION

Level

Reference

(

On )

(

Off)

(

Blink )

NOTE

•

※

FRE. TEMP BUTTON

To set the freeze temperature, push

the button repeatedly to select from

level 1 (cold) to level 9 (colder).

The higher level you set, the lower temperature inside the unit.

REF. TEMP BUTTON

To set the refrigerator temperature, push

the button repeatedly to select from level

1 (cold) to level 9 (colder).

Control Level Table

⑤
④
③
②
①

FREEZE

Refrigerator

The freeze temperature can be set to any level from

level 1 (cold) to level 9 (colder).

The refrigerator temperature can be set to any level

from level 1 (cold) to level 9 (colder).

- At each level, the LED indicators turn on or off as

shown on the table.

Press REF. TEMP button repeatedly until the

desired level is reached.

- At each level, the LED indicators turn on or off as

shown on the table.

Press FRE. TEMP button repeatedly until the

desired level is reached.

For your convenience, your refrigerator temperature control has been preset in the factory.

Refrigerator temperature controller shall be set as “NORMAL” (level 5: -20℃ for Freeze

and 3℃ for Fridge if your refrigerator is installed first time or has been switched off for a long time.
When accidental power off happens and the power is reconnected, please check the status of

temperature controller. User is suggested to set according to your actual application conditions

and normal recommended setting is NORMAL.

FRE. TEMP

REF. TEMP

colder

NOTE

cold

LED No.
LED No.
LED No.
LED No.
LED No.