Samsung RFG296HD Manuel D’Utilisation

setting up

 

01

 SETTING

 UP

ADJUSTING THE FREEZER DRAWER 
LEVEL

1.  Locate the height-adjuster ( 1 ) in the freezer drawer. 

Unscrew the 8 Phillips screws ( 

2 ) slightly to loosen 

the door.

2.   Loosen the controller 

screw ( 

3 ) with a Phillips    

screwdriver (+).

3.   Find the best level to align the door slope.
    •  After  adjustment, 

tighten the 
controller screw 
and then the 
philips screws.

1

2

3

Freezer Drawer

Adjustment part

INSTALLING THE WATER 
DISPENSER LINE

A water dispenser with a filter is one of the helpful 

features on your new refrigerator. To help promote 

better health, the water filter removes unwanted 

particles from your water. However, it does not 

sterilize or destroy microorganisms. You may need to 

purchase a water purifying system to do that.

In order for the ice maker to operate properly, a water 

pressure of  20~125 psi (138~862 kPa) is required.

Under normal conditions, a 170 cc (5.75 oz.) cup can 

be filled in about 10 seconds.
If the refrigerator is installed in an area with low water 

pressure (below 20psi), you can install a booster pump 

to compensate for the low pressure.
After you have connected the water line, make 

sure the water storage tank inside the refrigerator is 

properly filled. To do this, press the water dispenser 

lever until the water runs from the water outlet.

Water line installation kits are available at extra 

cost from your dealer. 

We recommend using a water line installation kit that 

contains copper tubing and ¼” compression nut.

1.   First, shut off the main water supply.

2.   Locate the nearest cold water drinking line and 

install the pipe 
clamp and shut 
off valve.

3.  Connect the water line installation kit to the shut off 

valve.

Example)  The slope is about 0.08inch (2mm) as shown below. 

-  Rotate the height adjuster to -2.0 to reduce the door slope.

Slope

Reference 

plane

DA68-02488A-11.indb   9

14. 5. 14.   �� 11:45