Samsung RS2622 Manuel D’Utilisation

5

Use padded hand truck as shown. If entrance width is 
less than 39

〃

, remove doors prior to installation and 

reattach doors according to procedure below.

Connect water lines and power cord. Adjust the 
clearance between the doors.

wait for an hour.
The refrigerator should get slightly chilled and the motor 
runs smoothly.

You can store food in the refrigerator. After starting the 
refrigerator, it takes a few hours to reach the appropriate 
temperature.

●

●

Open the freezer and refrigerator doors, and

then take off the front leg cover assembly by
turning the three screws counter-clockwise.
Remove the screw from clamp disconnect, the
water tube by pressing the coupler, and pulling
the water tube away.

With the door closed, remove the upper hinge

cover using a screwdriver, and then disconnect
the wires. Remove hinge screws and ground
screw counter-clockwise, and take off the upper
hinge. Take care removing the door to ensure that
it does not fall on you.

Remove the door from the lower hinge by

carefully lifting the door so as not to damage the
water tube. Remove the lower hinge from the
lower hinge bracket by lifting the lower hinge. 

●

●

Insert the lower hinge in the bracket lower

hinge. Attach the freezer door by inserting the
hose in the lower side of the door into the hole in
the lower hinge and pulling the hose down.

Insert the upper hinge shaft into the hole. After

leveling between the upper hinge hole and the
hole of the cabinet. Reattach hinge screws and
screw in the clockwise direction. Connect the
wires. Put the front part of the upper hinge cover
on the front part of the upper hinge and reattach
from the front part of the upper hinge cover first.