Samsung RFG298AARS Manuel D’Utilisation

 

Setting Up

Removing any residual matter inside the water supply line 
after installing the water filter.

1.   Turn on the main water supply & turn off the valve to the water supply line.
2.   Run water through the dispenser until the water runs clear (approx. 6-

7minutes). This will clean the water supply system and remove air from the 

lines.

3.  Additional flushing may be required in some households.
4.   Open the Refrigerator door and make sure there are no water leaks coming 

from the water filter.

4.   Remove the filter cap and insert the filter into the filter 

housing.

5.    Slowly turn the water filter 90º clockwise to align with the 

printing mark on the cover, locking the filter in position. 

Make sure to align the water filter label mark with center of 

cover filter printing as illustrated. Remember, do not over-

tighten.

Reverse osmosis water supply

iMPoRtAnt : The pressure of the water supply coming out of a reverse osmosis  system going to the water 

inlet valve of the  refrigerator needs to be between 35 and 120 psi (241 and 827 kPa). 

If a reverse osmosis water filtration system is  connected to your cold water supply, the water pressure to the 
reverse osmosis  system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):

•   Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if 

necessary.

•  Allow the storage tank on the reverse osmosis system to refill after heavy usage.
•   If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a 

reverse osmosis system. Remove the water filter.

If you have questions about your water  pressure, call a licensed, qualified plumber. 

Be sure to flush the dispenser thoroughly or water may from it. 

This is due to the fact that there is still air in the line.

Setting up your French Door Refrigerator

Turn until the label 

is aligned.

Separation

of filter cap(red)

Cover filter.