Samsung RL28FBSI Manuel D’Utilisation

Page de 8
5
DISASSEMBLING PARTS
Refrigerator shelf
Draw out it till the block, lift the shelf rear and pull 
it out. 
(position the shelf as per the container's height)
Fruit and vegetable tray and cover
Pull out the fruit and vegetable tray.
Drive up the cover head and put it out.
Freezer tray
Draw out it till the block, lift the shelf rear and pull 
it out.
Egg guard and bottle guard
Lift them up to dismantle it.
The wire bar of the bottle guard may vary as per 
requirement. 
REPLACE OF BUILT-IN LIGHT
Pull out the plug
Turn off the screw in the lampshade back press the 
center by fingers and push back to take out the 
lampshade.
Turn off the bulb counterclockwise.
Screw on the bulb clockwise.
Hang on the hook under the cover and turn upward 
to push into the upper hook.
Lamp parameter: 220V/240V, 15W
8
HOW TO USE
Cover
Moisture 
control 
slide
Fruit and 
vegetable 
tray
Partition
FRUIT AND VEGETABLE COMPARTMENT
You may adjust the moisture of the fruit and vegetable 
compartment by the moisture control slide. The slide 
towards the two sides may increase the moisture, vice  
versa.
The partition of the fruit and vegetable tray separates 
the fruit and vegetable compartment into two parts. 
You are allowed to adjust it according to the fruit and 
vegetable types and quantities to meet a satisfactory 
need of storage space. 
The fruit and vegetable compartment is able to preserve 
the water content and freshness of the fruits and 
vegetables as it is sealed to prevent cold air touching 
the fruits and vegetables. It is appropriate to the storage 
of vegetables and fruits.
Caution:
Tropical fruits, such as banana and pineapple are 
not recommended.
The temperature is adjusted by the slide under the 
control of temperature controller. The signs,  strong ,  
mediate  and  weak , on the knob receptively indicate 
the inside temperature condition. Under the same 
circumstance, stronger the knob reflects, lower the 
inside temperature is.  Close  means stopping working.
 
In normal use, adjust the slide at the  mediate  and 
 change it to the location between  weak  and  mediate  
 if any hot weather. If the room temperature is below 
 15 
,  then open the season switch and change the 
 slide to the location between  mediate  and  strong . 
 If the room temperature is below 10 
, it's a must to 
 locate the slide at the Winter area.
 
MECHANICAL TEMPERATURE ADJUSTMENT
 
Season switch
 
Temperature adjustment
¹Ø