Samsung RM255BABB Manuel D’Utilisation

Page de 88
DISASSEMBLY AND REASSEMBLY
1) Slip the compression nut and plastic ferrule
through the plastic tube.
2) After inserting the sleeve, tighten the compression
nut onto 1/4” compressionfitting(union).
Connect the water line to the refrigerator.
Water line must be connected to drinkable water only.
Cut off 1/4 inch squarely to prevent leaks when reconnected.
Do not overtighten the compression
nut.
NOTE
NOTE
3) Slip  the compression ferrule and nut on
copper (or plastic) tubing as shown.
Tighten the compression nut onto the
compression fitting(union).
4) Turn water on and check for any leakage. 
Compression Nut
Compression fitting
Sleeve
Compression Nut
Ferrule
Ferrule
1) Open the cartridge cover as shown by pulling and pushing up at the front,
2) Remove the water filter from the box then position the arrow of the cartridge in line with the cartridge cover.
3) Insert the filter as shown and Push until you hear the clicking sound.
4) Close the filter cartridge cover.
Install the water filter.
The water filter cartridge is located at the upper right corner of the refrigerator compartment.
When the display in the control panel “filter change”, it is mecessory to be changed the filter cartridge.
NOTE
Under the high water pressure, water drops may happen. 
If you put the small tray beneath the hole of filter cover, it will be helpul to clean the shelf.
NOTE
Be sure to align the hook of the filter catridge and housing.
NOTE
NOTE
After changing filter cartridge, drain the first six glassful of water off to remove the trapped air.
Do not repeat pushing and pulling, water pressure and trap will make a spurt of water.
46
46