Samsung RF267ABPN Manuel D’Utilisation

Setting Up

sEtting uP tHE REFRigERAtoR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of
the appliance. By completing the following steps, your Refrigerator should be fully operational.

1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the

Refrigerator. Refer to installation instructions in this manual.

2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled

and the motor will run smoothly.

4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store

food and drinks in the Refrigerator after the temperature is sufficiently cool.

REMoVing tHE REFRigERAtoR DooRs

If the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.

Disassemble the Refrigerator doors

1. With the door opened, remove the Top Table cap

(

) with a Flat head screwdriver, and close the

door.

Remove the 3 screws holding down the Top Table

and remove the Top Table(

tools you will need

Philips screwdriver

10mm Socket Wrench

Allen wrench(3/16”)

Flat-blade screwdriver

Pliers

Check the accessory list below.

Water filter

(DA29-00002B)

Hex wrench

(DA80-00002C)

Fastener

(DA60-00143B)

Compressin fitting

(DA62-00305A)

Compression nut

(DA74-00070B)

Clip fitting lock(red)

(DA61-04522A)

Clip fitting lock(blue)

(DA61-04521A)

01
s

tting