Samsung 65603 Manuel D’Utilisation

Page de 57
10
REFRIGERATOR INSTALLATION
 WARNING
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from the  
refrigerator before using. Do not remove any warning- 
type labels, the model and serial number label, or the  
tech sheet that is attached to the back wall of the  
refrigerator.
To remove any remaining tape or glue, rub the area briskly 
with your thumb. Tape or glue residue can also be easily 
removed by rubbing a small amount of liquid dish soap 
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleansers to remove tape or glue. These
products can damage the surface of the refrigerator. For 
more information, see the Important Safety Instructions 
section.
Refrigerator shelves are installed in the shipping position. 
Please reinstall the shelves according to your individual 
storage needs.
• To reduce the risk of electric shock, do not install  
the refrigerator in a wet or damp area.
• Select a place where a water supply can be easily  
connected for the automatic icemaker.
REQUIRED TOOLS
The following tools are needed to install and adjust  
the refrigerator.
 CAUTION
 WARNING
 CAUTION
Excessive Weight Hazard
Use two or more people to move and install the  
refrigerator. Failure to do so can result in back or  
other injury.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the  
refrigerator for cleaning or service, be sure to protect 
the floor. Always pull the refrigerator straight out when
moving it. Do not wiggle or walk the refrigerator when 
trying to move it, as floor damage could occur.
Explosion Hazard
Keep flammable materials and vapors, such as  
gasoline, away from the refrigerator. Failure to do  
so can result in death, explosion, or fire.
Avoid placing the refrigerator near a heat source,  
direct sunlight, or moisture.
Phillips-Head 
Screwdriver (+)
Flat-Head  
Screwdriver (–)
Socket Wrench 
13/32 in. (10 mm) 
(for bolts)
Hex Wrench  
3/16 in. (4.75 mm)
(for middle hinge)
Hex wrench  
5/32 in. (4 mm)
(for middle hinge shaft)
DA99-01921A (EN-1).indd   10
2010.3.16   1:7:20 PM