Samsung HP2777AT Manuel D’Utilisation

58

The refrigerator does not work at all or it does not chill
sufficiently
• Check that the power plug is properly connected.

• Is the temperature control on the display panel set to the

correct temperature? Try setting it to a lower temperature.

• Is the refrigerator in direct sunlight or located near a heat

source?

• Is the back of the refrigerator too close to the wall?

The food in the refrigerator is frozen
• Is the temperature control on the display panel set to the

correct temperature? Try setting it to a warmer temperature.

• Is the temperature in the room too low?

• Did you store the food with a high water content in the cold-

est part of the refrigerator.

You can hear unusual noise or sounds
• Check that the floor is levelled and stable.

• Is the back of the refrigerator too near to the wall?

• Was anything dropped behind or under the refrigerator?

• A “ticking” sound may be heard from inside the refrigerator,

This is normal and occurs because various accessories
contract or expand.

The front corners and sides of the cabinet are hot; con-
densation occurs.
• Anti-condensation are installed in the front corners of the

refrigerator to prevent condensation. 

• Condensation can occur when you leave the door open for

a long time.

• Did you stop the ice making function?

• Is there any ice in the ice storage unit?

• Is the water pipe connected and the shut-off valve open?

• Is the freezer temperature too warm?

(Set the temperature lower .)

• Did you wait for 12 hours after installation of the water sup-

ply line before making ice?

• The bubbling comes from the refrigerant circulating in the

refrigerator and is normal.

There is a bad smell in the refrigerator
• Wrap strong smelling food so that it is airtight.

Throw away any rotten food.

Frost forms on the wall of the freezer
• Is the air vent blocked?

• Allow sufficient space between the foods stored for efficient

air circulation.

• Is the door closed properly?

• Is the water pipe connected and the shut-off valve open?

• Is the water supply pipe crushed?

• Is the water tank frozen because the refrigerator tempera-

ture is too low? Select a warmer setting on the display
panel.

• If the HomePAD

TM

does not power on,it's because the

battery is discharged or its power button has not been

pressed.

• Connect an adaptor to the HomePAD

TM

or set it in the dock-

ing station.

• The power LED lights up. If the power

LED does not light, check the power connection of the

adaptor the setting of the HomePAD

TM

in the docking sta-

tion.

• Press the power button.

• If the unit still doesn't come on, press and hold the Power

button for at least 6 seconds.

TM

• ESSID may not match or WEP is set incorrectly.

• Press HomePAD

TM

properties Icon when HomePAD

TM

initial-

ization screen appears.

• Select NETWORK button. Press "Go" button in ESSID

Setup

within the Network Setup .

• Check ESSID number.

• The HomePAD

TM

ESSID must match the ESSID number

on the Home Station label. If the numbers do not match,

go to HomePAD

TM

Properties, then select NETWORK.

Next, go to ESSID Setup and enter the correct ESSID num-

ber.

• Restart the HomePAD

TM

.

• If the ESSID numbers match, press "Return to Network

Main" button.

• Press "Go" button in the HomePAD

TM

Encryption setup.

-.Check WEP to see if it is enabled

-.If WEP is Enabled, select Disable.

• Press "Go" button in the Home station Encryption setup

-.Check WEP to see if it is enabled

-.WEP is Enabled, select Disable.

-.If WEP setting screen of Home Station does not appear, 

consult a service center.

• Turn the power on after turning HomePAD

TM

off.

• If UI functions do not run, contact a Samsung service cen-

ter.

DA68-01174A  12/14/02 11:06 AM  Page 58