Tektronix TVS600 & TVS600A Series Manuel D’Utilisation
CALCulate Subsystem
2–72
TVS600 & TVS600A Command Reference
Execution Error –222, “Data out of range”
Attempted to set LOW to an illegal value.
Attempted to set LOW to an illegal value.
None
Command:
CALC1:WMP:LOW -10.0
Query:
CALC1:WMP:LOW?
Response:
-10.0E+0
CALCulate:WMParameter:HIGH
CALCulate:WMParameter:LMEThod
CALCulate:WMParameter:LMEThod
CALCulate:WMParameter:LMEThod
CALCulate:WMParameter:LMEThod?
CALCulate:WMParameter:LMEThod?
Sets or queries the method for calculating the LOW (most negative) value for
time and amplitude waveform measurements.
time and amplitude waveform measurements.
ABSolute — specifies that LOW is set to the value of CALCulate:WMPara-
meter:LOW.
meter:LOW.
AUTO — selects the MODE method of setting LOW when the histogram
function is able to detect a consistent level below MID. Otherwise, the
PEAK method is used. The AUTO method is effective when you are not
certain what type of waveform to expect.
function is able to detect a consistent level below MID. Otherwise, the
PEAK method is used. The AUTO method is effective when you are not
certain what type of waveform to expect.
MODE — selects the level for LOW based on a peak histogram function
which looks for a greater than average number of data points at a level below
MID. This method is useful to ignore spurious peaks on a digital logic
waveform, such as a TTL clock signal.
which looks for a greater than average number of data points at a level below
MID. This method is useful to ignore spurious peaks on a digital logic
waveform, such as a TTL clock signal.
PEAK — specifies that LOW is set to the lowest amplitude data point in the
acquisition record. This method is useful for a sinewave or triangle
waveform.
acquisition record. This method is useful for a sinewave or triangle
waveform.
CALCulate<n>:WMParameter:LMEThod <method>
CALCulate<n>:WMParameter:LMEThod?
Errors and Events
Dependencies
Examples
Related Commands
Syntax